How to Connect Teleworker AP VPN to Your Network

Step 1.  Remove access point from box and flip it over to reveal the attached mounting plate.

Step 2.  Hold access point in so that it matches up with the below picture and slide the mounting plate up and lift it off of the access point.

Step 3.  Locate the Ethernet port and power port on the access point in the below picture.

Step 4.  Plug the supplied Ethernet cable into the rectangular Ethernet port, then plug the other end into your home router.

Step 5.  Plug in the power brick into a 110 outlet and plug the other end into the round power port on the AP

Step 6.  Wait 15 to 20 minutes for the Access Point to boot and pull down its configuration.  The light on top of the AP will turn solid green when it is ready.  Leave your laptop powered off until the light is solid green.

Step 7.  Boot your laptop and let it sit at the logon screen for 2 or 3 minutes to give it time to attach to the wireless SSID and then log in.  It should operate like it does when you are on our network.  You should also see the green light on the AP change to blue.  This means your laptop is connected.